Creating a Gift Tag Using Stampin'Up! Kindest Gnomes Bundle!
December 08, 2022
Today we're creating a Gift Tag Using Stampin'Up! Kindest Gnomes Bundle! Tuesday with this same bundle we created Christmas card--if you missed it...check it out here...https://www.sandilovesstamping.com/2022/12/cute-christmas-card-with-stampinup-kindest-gnome-dies.html.
This little gnome has a hold on me and I just can't stop using him...here's today's tag
& a but closer...
We're using the same color scheme & designer paper used for the Christmas card Tuesday making this economical using supplies.
However, the paper used for the hat comes from the Brights 6 X 6 DSP...that small plaid was perfect for a gnome hat.
The beard has a tinge of blue around the edge. I took a bit of Pacific Point ink on a sponge dauber & went around the edge of the beard to help define it...the blue blends with the other colors & makes that beard nice & distinct.
The base tag is a die from the Designer Tag set. It has a slit at the top & bottom to allow the ribbon to go in through the bottom, up the back, & out the top forming a loop at the top. To keep that ribbon in place we used white cardstock on which you can write the "to/from" info.
Stop back by next week and see what card & tag we created.
I'll give you full directions below followed by the supply list to order your supplies.
Remember: Sandi's Super Santa Sale is going on--12/5-12/9--each day a different sale (24 hs only)
You can shop today's sale here Day #4.
Directions:
1. Die cut tag from Pacific Point cardstock (Designer Labels dies).
2. Cut 2 1/2 X 2 1/2 snowflake designer paper (Storybook Gnomes DSP); adhere to tag front with glue.
3. Cut approximately 14" White Glittered Organdy ribbon; fold in half & thread from front to back through bottom tag slit & out through top slit.
*Cut approximately 12" silver twine (Simply Elegant Trim), tie around the top ribbon loop in a bow.
4. Cut 2 1/2 X 2 1/2 Basic White cardstock; glue to back of tag.
5. Die cut the following:
*feet from black cardstock; adhere with glue
*beard from white glimmer; dauber with Pacific ink around edges & adhere with glue dots
*hat from Pacific Plaid; adhere with dimensionals
*nose from Gray; adhere with dimensional
6. Adhere 3 Pool sequins (Adhesive backed sequins & Gems) --see photo.
7. Stamp 'warm wishes' in Craft White ink on Pacific Point; sprinkle with white embossing powder. Heat with heat tool until shiny white.
*Cut 1/2 X 1 3/4 silver foil; adhere to back of label with glue dots. Adhere this to tag front with dimensionals.
Your tag is ready for giving!
Supplies: click on any image below & you'll be in my store--order your supplies now!
